Securing The Machine - John Bean T5540 Série Manuel D'utilisation

9
10
22
GP versions only:
Caution: possibility of flying debris such as dirt and
dust. Wear safety goggles and, if necessary, ear
plugs.
Press the inflation pedal to check inflation
through the air ports in the jaws / nozzle.
• Fit the cabinet lateral panel.
2.8

Securing the machine

• We recommended that you secure the machine
to the floor at the four points envisaged using
M10 anchor bolts and/or suitable dowels
2.9 Transporting the machine / Resiting
Suitable anchoring, lifting and and internal transport
devices must be used for transporting the machine.
Always mind the machine centre of gravity.
Fig. 9 Transport using a fork-lift truck
• To transport the machine, secure the machine
tower and mounting arm so that they cannot tilt
and/or shift.
• Tilt the machine slightly.
• Lower the machine onto the fork-lift truck and
position it so that it will not tip over while being
transported (always mind the machine centre of
gravity.
Fig. 10 Transport using lifting equipment
• To transport the machine, secure the machine
tower and mounting arm so that they cannot tilt
and/or shift.
• Position the lifting cables or other suitable lifting
gear on the machine as illustrated in Fig. 10.
• When lifting the machine, make sure the lifting
cables are correctly positioned (mind the centre
of gravity of the machine) and the machine does
not tip over while being transported.
If you resite the machine, the instructions for first
installation still apply.