Yamaha Banshee 350 Manuel Du Propriétaire page 88

1
2
a
1. Locknut
1. Contre-écrou
1. Contratuerca
A. Spring length
A. Longueur du ressort
A. Longitud del resorte
b
2. Spring preload adjusting nut
2. Écrou de réglage de la
précontrainte du ressort
2. Tuerca de ajuste de la
precarga del muelle
A
Adjust the spring preload as follows.
1. Loosen the locknut.
2. Turn the adjusting nut in direction a to
increase the spring preload and in direction
b to decrease the spring preload.
3. The length of the spring (installed) changes
1.5 mm per turn of the adjusting nut.
NOTE:
A special wrench can be obtained at a Yamaha
dealer to make this adjustment.
Measurement A:
Installed length:
Minimum (hard):
Standard:
Maximum (soft):
4. Tighten the locknut to the specified torque.
Tightening torque:
54 Nm (5.4 m0kgf)
4-31
213.5 mm
220.5 mm
228.5 mm