Télécharger Imprimer la page

König Electronic HAV-MCS30 Mode D'emploi page 6

Masquer les pouces Voir aussi pour HAV-MCS30:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
Note:
-
Please ensure the correct time is set before setting the Timer on/off function.
-
The On/Off timer can only operate if the unit is switched to standby mode when not in use. In
timer mode, the unit will switch on in the last mode that was in use.
If you wish to wake to music from your iPod® ensure that the iPod® is connected.
If you wish to wake to music from a CD, ensure that a CD is loaded.
If you wish to wake to radio, ensure that a radio station is tuned.
If you wish to wake to music from USB or SD/MMC, please ensure that a USB device or SD/
MMC card is inserted.
SLEEP setting (Automatically turn off)
The unit can be programmed to switch off after a set time, for example
if you wish to go to sleep while listening.
The Sleep time can be set at 10, 20, 30, 40, 50, 60, 70, 80 or 90 minutes.
Press the SLEEP/12/24HR button repeatedly until the desired sleep time
is shown in the display.
The unit will automatically switch off after the selected time.
Note: If the CD playing time is shorter than your selected sleep time, the music will stop at the
end of disc.
BASIC OPERATION
Turn on the unit
Press the STANDBY (5, 30) button to turn on or turn off the unit.
Operating mode selection
Press the TUNER/BAND (7, 45) button, (8, 31) button, CD/USB/SD (9, 46) button or AUX (43)
button to select the different operating modes.
PLAY / PAUSE / PRESET- (14, 47) button:
Press this button to begin playback or pause a CD. In Tuner mode, press this button to skip to
a previous preset radio station.
STOP / PRESET+ (15, 32) button:
Press this button to stop the playback of a CD. In Tuner mode, press this
button to skip to the next preset radio station.
VOLUME (18, 48) button:
Press repeatedly to adjust sound level output from 00 (minimum) to 40
(maximum).
MUTE (44) button:
Press this button to mute the sound output from the unit „VOL-OFF" will
show in the display. To restore sound output, press the button again
„VOL-ON" will show in the display.
EQ (19, 50) button:
Press this button to select one of the 5 preset sound equalizer settings.
These are FLAT, ROCK, JAZZ, POP and CLASSIC.
TUNER OPERATION
Manual operation
1. Press the STANDBY (5, 30) button to turn on the unit
2. Press TUNER/BAND button repeatedly to select MW or FM.
3. Press / /TUNING  or / /TUNING  (20, 35) buttons to manually tune up or
down the current waveband in 0.05MHz increasements.
6

Publicité

loading