Clatronic HM 2642 Mode D'emploi & Garantie page 23

44054-05- HM 2642 Handmixer
Ensure that the machine is not connected to the mains.
Assembly of the Whisk/Kneading Hook
Press the two whisks or kneading hooks on the bottom by turning slightly until they
lock in place.
Note: The marked kneading hook (6) has to be inserted into the right-hand opening
of the mixer!
1. Please ensure that the speed switch (2) is turned to "0/OFF".
2. Connect the mixer to a properly installed power socket, 230 V, 50 Hz.
3. Insert the kneading hook or whisk into the food to be mixed.
Set the desired speed with the speed switch (2):
1 Kneading hook: butter, potatoes, light mixture
2 Whisk: sauces, milk mix, etc., desserts, pudding, egg white, frothy cream.
4. Tilt the machine slightly up and down.
Note: For optimum results use high-walled vessels that are not too large.
Turbo Switch (1)
This is for switching to maximum speed for a short time. Press at short intervals for
pulsed mode operation.
WARNING: Do not use this function for more than 2 minutes!
Releasing the kneading hook (6/7) / whisk (5)
In order to release the hook, press the release button (3).
• Disconnect the machine from the mains.
• Clean the machine after use with a dry cloth.
• Clean the equipment in the usual way in soapy water.
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
27.08.2002 12:59 Uhr
Initial Operation
Using the Machine
Cleaning
Seite 23 (Sch
GB
23