CABASSE STREAM BASE Notice D'installation page 27

BLUETOOTH CONNECTION
3
STREAM BASE is set in on open mode for Bluetooth connections.
Select "Cabasse STREAM BASE" in the available Bluetooth devices list.
Select the BLUETOOTH input with
If a Bluetooth source is already connected to STREAM BASE, disconnect this item before
selecting a new one.
BLUETOOTH CONNECTION WITH AN ANDROID TABLET: see the English explanation on
page 38.
CONNECTION AND USE OF STREAM BASE WITH AN APPLE COMPUTER: see the English
version page 39.
TO DESACTIVATE THE BLUETOOTH FUNCTION: select the BT input with the remote control,
then press successively the following keys: "Home Cinema" or "NIGHT", then "MUTE", then
"NEXT".
To activate the Bluetooth function , select the BT input with the remote control, then press
successively the following keys: "Home Cinema" or "NIGHT", then "MUTE", then "PREV".
LAN WIRE CONNECTION TO THE ETHERNET NETWORK
3
The LAN (Ethernet) wire connection ensures a constant and optimum transfer rate. Use
it if music reproduction stops or is erratic under Wi-Fi mode, because of a saturated Wi-Fi
bandwidth or the distance between the router and the Stream unit being too long.
Use a RJ45 type cable to connect STREAM BASE to the domestic router.
The connection is running when the blue LED "ETH" stops flashing and remains on. The WIFI
connection is then automatically turned off.
ATTENTION: set up the router on DHCP mode.
WIFI DIRECT MODE
4
Wi-Fi direct allows to play with wifi quality all the audio tracks available in the tablet or the
smartphone as well as those availble in the hard-disk or USB-stick connect to the USB input
of STREAM BASE, without need of a wifi network. Internet sources such as Vtuner, Deezer and
the STREAM BASE firmware updates are not available.
Activate the STREAM BASE, Install and open the StreamCONTROL app on your tablet/
smartphone and select "Use this device in standalone mode" instead of "configure this audio
device". Follow the instructions and start playing your music.
key on the Stream remote or on the Stream BASE.
8
Press "RESET" before starting a new connection process
(wired, auto, easy, manual) or connecting to a new
router.
27