7- Specific Installations; 8- Post-Installation Check List - Facnor FlatDeck FD090 Notice De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

7- SPECIFIC INSTALLATIONS

Installation without deflector wheel or when using a sail with shorter luff:
15°
40mm – 140mm
'
A

8- POST-INSTALLATION CHECK LIST

minimum
40 mm
CLEAR SWIVEL ?
GENOA
HALYARD, OK ?
RIG
READJUSTED ?
F a c n o r – I n s ta l l a ti o n m a n u a l - F l a tD e c k f u r l i n g a n d r e e f i n g s ys te m – r e v 2 0 1 8
 Without
If the halyard swivel is not used, fix a block on the mast
(fig. A'), so that the halyard runs off at 15° to the
forestay. Also insure that the top cap is positioned
between 40mm and 140mm from the bottom end of the
forestay terminal.
 Sail with shorter luff
The halyard swivel virtually eliminates halyard wrap ;
B'
however, when using a shorter sail, rig a short strop (fig.
B') between the head of your sail to allow the top of the
halyard swivel to be positioned around 50mm from the
top section cap, when your sail is fully hoisted.
The furling line runs at 90° to the foil sections
90°
(if not, see p.30 «adjusting the furling line guide)
The bottom pin of the forestay is correctly bolted, at
least one thread is showed beyond the bolt
(If the furling system is fiited with link plates, check the upper fixing
srews)
When the sail is hoisted and the halyard is tensioned correctly :
distance between halyard deflector & bottom end of the top
minimum
75 mm
forestay terminal
distance between halyard swivel & top cap
=75mm minimum – 150 mm maximum*
Recommended datas (may vary according to rigging fitting)
* space to allow for change in luff length of Genoa. The bigger is the
distance between the top swivel and the top cap, the more important is
the risk for the halyard to twist round the forestay. Make sure that the
halyard/forestay angle is bigger than 15° (if not, see page 29)
The swivel is clear of any halyard
The Genoa halyard is correctly tensioned
The rig is adjusted in tension as initially
deflector
:
LS/LX330)
=40mm minimum – 140mm maximum
wheel
(installation
(i.e. Storm Sails and Working Jibs)
for
the
:
30

Publicité

Chapitres

Table des Matières
loading

Table des Matières