Bosch PKP 7,2 LI Notice Originale page 17

OBJ_BUCH-1210-002.book Page 17 Friday, December 3, 2010 4:07 PM
Assembly
Battery Charging (see figure A)
Observe the mains voltage! The voltage of the power supply
must correspond with the data given on the nameplate of the
battery charger. Battery chargers marked with 230 V can also
be operated with 220 V.
The battery is supplied partially charged.
To ensure full battery capacity, completely charge the battery (at
least 1.5–2 hours) before using for the first time.
The glue gun cannot be used during the charging procedure; it is
not defective, when it does not function during the charging pro-
cedure.
The lithium-ion battery can be charged at any time without reduc-
ing its service life. Interrupting the charging procedure does not
damage the battery.
The "Electronic Cell Protection (ECP)" protects the lithium ion
battery against deep discharging. When the battery is discharged,
the glue gun is switched off by a protective circuit: The glue is no
longer heated.
After the automatic shut-off of the glue gun, do
WARNING
not press the On/Off button again. The battery
could become damaged.
Battery Charge
Indicator
red green
–
–
–
–
Flashing Continuous light
– Plug the mains plug of the charger 2 into a socket outlet. After-
wards, place the glue gun into the charger cradle.
Disconnect the battery charger from the mains supply when not
using it for longer periods.
Protect the battery charger against moisture!
Observe the notes for disposal.
Bosch Power Tools
Meaning
The battery is being charged
The battery is fully charged
The battery has less than 30% of its
capacity and should be charged
The battery is completely discharged
1 609 929 Y25 | (3.12.10)
English | 17