Vimar Eikon 20446 Notice Technique page 35

• AUTOMATIC PROGRAM.
Used to modify the automatic program for each day of the
week .
Programming starts from hour 0 and ends with the selection of
the temperature level for hour 23 .
- Press key P until the required mode is displayed (name of day
blinking, PROG and temperature histograms lit up steady);
using key "" "" set the day of the week, then press the
OK key .
- Using key "" "" set the valid temperature level for the
selected time (histogram blinking), then press the OK key .
- Repeat the above point for all the hours from 0 to 23; scrolling
is done with keys C and OK (to pass on to the next hour press
OK, to go back to the previous hour press C) .
- After setting hour 23 the display will show COPY blinking; by
pressing OK the program that has just been set will be copied
onto the next day whereas by pressing C the programming
can be done hour by hour .
N.B. In addition, it is possible to set the time to activate the
temperature levels in steps of 15 minutes .
After selecting the time to set the temperature level, press
in sequence key F (the interval of 15, 30 and 45 minutes is
shown on the display at the top left by the selected time) .
Example: You want to program the timer-thermostat so that on
Thursday at 7:45 it moves onto temperature level T3 .
- Press key P until the automatic program is displayed;
- Using key "" "" select Thursday (GIO blinking);
- Press the OK key to select hour 7 (histogram blinking);
- Using key "" "" set the temperature level on T3;
- Press key F to display 07:45 at top left on the display;
- Press the OK key to confirm the setting .
ENGLISH - 31