Installation Instructions; Install Pedestal - Whirlpool WFP24JW0 Instructions D'installation

Installation Instructions

Install Pedestal

Follow these instructions to install the pedestal on the washer
or dryer.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
1. To install the washer or dryer onto the pedestal, first thread
a locknut onto each foot. Screw each locknut down to the
rubber base of the foot.
2. When all 4 locknuts are in place on the feet, screw a foot
into each corner brace of the pedestal. Adjust the feet so
that the rubber pads extend just below the bottom of the
pedestal and keep the pedestal at least 1/8" (3.175 mm) off
the floor.
NOTE: For more stability, do not raise the bottom of the
pedestal any higher than necessary to clear the floor on all
four sides.
3. Set the pedestal in its final location.
4. Place a level on the pedestal to ensure that it is level from
front to back and side to side. If necessary, adjust the feet
up or down to level the pedestal.
5. Once it is level, use a 9/16" (14 mm) open end wrench
to thread each locknut to the bottom of each corner brace.
Tighten until locked into place.
6. Place the washer or dryer on the pedestal as shown.
The front and side edges should line up. For Dryers screw
all feet in completely then unscrew 3 full turns.
7a. Washer Installation: If installing the washer on the
pedestal, use 4 of these brackets in these locations on the
pedestal.
To install the brackets, slide the open-ended portion of
the bracket over one of the feet of the washer.Center the
two prongs of the bracket on top of the foot. Repeat this
step with the other three brackets and feet. Use one
bracket on each of the four feet to properly secure the
washer.
Washer foot
7b. Dryer Installation: If installing the dryer on the pedestal,
use this combination of brackets in these locations on the
pedestal.
To install the brackets, slide the open-ended portion of
the bracket over one of the feet of the dryer. Center the
two prongs of the bracket on top of the foot. Repeat this
step with the other three brackets and feet. Use one
bracket on each of the four feet to properly secure the
washer.
Dryer foot
Pedestal bracket
Front
Dryer foot
Pedestal bracket
3