Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Slide the brackets directly against the side or top of the
pedestal as shown above in Step 7.
9. Insert the carriage bolt through the slot in the mounting
bracket and the pedestal. Repeat this step for the other
brackets. Attach the self-locking nut on all carriage bolts.
Use a 7/16" (11 mm) open end wrench to completely
tighten the self-locking nuts.
10. With the washer or dryer locked securely into place
on the pedestal, slide the washer or dryer and pedestal
to their final location.
11. Place a level on top of the washer or dryer and ensure
that it is level from front to back and side to side. If it is
necessary to adjust the washer or dryer feet to level it
on the pedestal, the brackets may need to be temporarily
loosened.
To adjust the pedestal feet:
Reach inside the pedestal and use a 7⁄16" (11 mm) open end
Q
wrench to loosen the locknut.
Adjust the pedestal feet up or down. Be sure to completely
Q
tighten the brackets and locknuts again after the washer or
dryer is level.
12. Follow the Installation Instructions that came with your model
to finish installing or reinstalling your washer or dryer.
4
Publicité
Table des Matières
