Publicité
Targeted Scanning Mode
In order to read a bar code (switch option only)...
•
press and hold the switch. An aiming pattern will
appear.
•
with the aiming pattern fairly centered over the bar code
to be read, release the switch to read the label.
NOTE
Troubleshooting
If the scanner is not operating properly, the following checks
should be performed:
1. If the scanner uses an external power supply and the external
power supply has failed, the scanner will not operate.
Exchange the power supply with a known good power sup-
ply and retest operation.
1
2. Verify the interface cable is securely attached to the host.
Consult your technical support personnel or refer to your
host system manual to verify the proper connection for the
scanner.
Quick Reference Guide
The scanner will not read bar codes while the
switch is pressed.
Targeted Scanning Mode will read bar codes
in any orientation.
The scanner will return to full pattern Omni
Mode after a configurable time has elapsed.
2
3
4
5
3
Publicité
