LOTRONIC AFX LiGHT SPOT180LED Manuel D'utilisation page 5

CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it is always advisable to
connect a DMX signal terminator.
CONTROL PANEL
To access the main menu press the MENU button. Press the UP or DOWN buttons
until you reach function you wish to change. When you reach the function you
wish to change, press the ENTER button. When a function is selected, use the UP
or DOWN buttons to change the function settings. Once your changes are made,
press the ENTER button.
FUNCTION MENU
Address Set
Run mode
SETUP
System Information
DMX CHANNELS
CH10 CH12 14CH
CH1 CH1 CH1
CH2
CH2 CH2 CH3
CH4
©Copyright LOTRONIC 2017
DMX Address setting
DMX
AUTO
SOUND
MANUAL
Advanced setting
Ver V1
DMX address
Temperature
16CH Function
CH1 Pan
CH2 Pan fine
CH3 Tilt
CH4 Tilt Fine
Auto 1 – Auto2
Manual Test -> Function and Operation
Pan reverse
Tilt reverse
Display
Screen Reverse
Channel (16/14/12/10 Select)
Sensitivity (01-100)
Motor zero
Reset
Factory Set
Channel
Discription
Value
0-255 0-540°
0-255 Pan Fine
0-255 0-270°
0-255 Tilt Fine
SPOT180LED
Resistance 120 ohm
between pin 2 (DMX-)
and pin 3 (DMX+) of
the last fixture.
Page 5