Publicité
Les langues disponibles
Les langues disponibles
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
The LED moving head provides
a unique mounting bracket
assembly that integrates the
bottom of the base, the
included 'omega bracket' and
the safety cable rigging point in
one unit (see illustration).When
mounting this fixture on a truss,
be sure to use an appropriate
clamp with the included omega
bracket using a M10 screw
fitted through the center hole
of the 'omega bracket'. As an
added safety measure, be sure
to attach at least one properly
rated safety cable to the fixture
using one of the safety cable
rigging points integrated in the
base assembly.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support for
further instructions. Continuing to use the unit may cause serious damage.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 500 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 32 fixtures
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.
©Copyright LOTRONIC 2017
SPOT180LED
Page 4
Publicité
