Hoover Freespace Cyclonic TFS 7207P Mode D'emploi page 6

EN
IMPORTANT SAFETY REMINDERS:
This cleaner should only be used for domestic cleaning, as described in this User Guide. Please
ensure that this guide is fully understood before operating the appliance.
Warning: Electricity can be extremely dangerous. This appliance is double insulated and must not
be earthed.
Important: The wires in the mains power lead are coloured in accordance with the following code:
Blue - Neutral
Static electricity: Some carpets can cause a small build up of static electricity. Any static electric-
ity discharge is not hazardous to health.
Remember: After use, switch the cleaner off and remove the plug from the electricity supply.
Always switch off and remove the plug before cleaning the appliance or attempting any mainte-
nance.
Safety with children, elderly or the infi rm: Do not let children play with the appliance or its con-
trols. Please supervise the use of the appliance by older children, the elderly or the infi rm.
IT IS IMPORTANT THAT YOU DO NOT
• Position the cleaner above you when cleaning the stairs.
• Use the cleaner out of doors on wet surfaces or for wet pickup.
• Pick up matches, hot ash, cigarette ends, hard or sharp objects or anything that may damage
the cleaner.
• Spray with or pick up fl ammable liquids, cleaning fl uids, aerosols or their va pours as this may
cause risk of fi re/explosion.
• Run over the supply cord whilst using the cleaner or remove the plug by pulling on the cord.
• Stand on or wrap the power cord around arms or legs when using the cleaner.
• Continue to use your cleaner if it appears to be faulty. If the supply cord is damaged, stop
using the cleaner IMMEDIATELY. To avoid a hazard, an authorised Hoover service engineer
must replace the supply cord.
• Remove the cyclonic cassette before removing the hose from the cleaner.
• Use the appliance to clean people or animals.
ASSEMBLING YOUR CLEANER
Remove the cleaner and accessories form their packaging. Please dispose of the packaging
material in a safe and conscientious way.
Insert the hose end into the cleaner, ensuring it clips and locks into position. To release: simply
press the two buttons on the hose end and pull (P1).
Fit the hose/handle and fl oor nozzle onto opposite ends of the telescopic tube (P2 & P3). The ac-
cessory tools can be stored on the tool holder fi xed to the telescopic tube (P3).
0565_5319_d2.indd Sec1:6 0565_5319_d2.indd Sec1:6
Brown - Live
6
25/03/2008 12:27:10 25/03/2008 12:27:10