Connections - Philips AZ 7381 Mode D'emploi

CONNECTIONS

Recharging the Philips battery pack on board
(supplied or optionally available)
AY 3361 NiCd battery pack for recharging on board
The battery pack will be recharged if the mains adapter is connected, the set is
switched off and you press the STOP 9 button.
Display indication during charging: CHARGE and
y y
Approx. charging time: 5 hours (NiCd)
Display indication when fully charged: FULL and
y y
Note: - Use only the Philips battery pack, as other rechargeable batteries cannot be
recharged on board.
Connecting the headphones
Connect the supplied headphones with the
p LINE OUT jack.
AY 3674 (AZ 7582: AY 3675)
Note : Use this jack also for connecting your HiFi system
(signal lead) or your car radio (adapter cassette or
signal lead). In both cases, the volume of the CD
player has to be set to position 8.
Use your head when using headphones
Hearing safety: Do not play your headphones at a high volume. Hearing experts
advise that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a
hazard and it is illegal in many countries. Even if your headphones are an open-air
type designed to let you hear outside sounds, do not turn up the volume so high
that you cannot hear what is going on around you.
8
(supplied)