Explore Scientific RPW3008 Mode D'emploi page 8

GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please en-
sure the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
when the display is dim.
AC/DC POWER ADAPTER
Only use a compatible AC/DC Power adapter (3.6V
100mA). Plug the power cable to the power jack
and the power adapter to a suitable power outlet.
8
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Select a channel, then press TX.
3. Insert 2x AAA (LR03)/1.5V batteries. Please en-
sure the polarities (+/-) of the batteries match upon
installation.
] displays, or
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TO SEARCH FOR A SENSOR:
Press and hold [
The sensor reception icon in the outdoor sensor area
shows the status:
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
] to initiate outdoor sensor search.
FLASH
(sensor found).
(searching for sensor) or