Xoro HTC1900D Manuel D'emploi page 82

DVB-T OPERATION GUIDE
Installation
Auto Scan
20.
The Auto Scan Menu is shown in picture 20. First,
select a country using LEFT or RIGHT. Then press
DOWN to highlight "Select Scan" and press
ENTER. A message will appear, asking if the re-
sults are to be saved. If not, the scan will begin. If
yes, another message, as shown in picture 21, will
appear, asking if the results will replace the exist-
21.
ing results, or be added to the existing results.
After choosing "Yes" or "No", the scan will begin.
Manual Scan
The Manual Scan Menu is shown in Picture 22. A
scan can be performed by setting the following
items: Country, Scan Type, Start Channel, Start
Frequency, End Frequency, and Bandwidth.
If the scan type is a single channel, then only the
country and start channel can be set. If the scan
22.
type is a channel range, then the country, start
channel, and end channel can be set. Use the UP,
DOWN keys to select an item and the LEFT,
RIGHT keys to change the settings. Once done,
go to "Start Scan" and press ENTER.
Default Setup
A message box will appear, as shown in Picture
23, asking if the user wants to reset the
23.
system to factory settings. After the settings are
reset, the First Time Installation message appears.
38