Worx WX331 Notice Originale page 5

1. ON/OFF SWITCH
2. SWITCH LOCK-ON BUTTON
3. FORWARD AND REVERSE ROTATION CONTROL
4. FUNCTION MODE SELECTION SWITCH
5. AUXILIARY HANDLE
6. ADJUSTABLE DEPTH STOP
7. DUST PROTECTION CAP
8. SDS-PLUS "QUIK-CHANGE" CHUCK
Not all the accessories illustrated or de-
scribed are included in standard delivery.
TECHNICAL DATA
Type WX331 WX331.1 WX332
(330-359-designation of machinery,
representative of rotary hammer)
Voltage
Power input
No load speed
Impact rate
Impact energy
Protection class
Drilling capacity max
Masonry
Steel
Wood
Machine weight
NOISE INFORMATION
When tested at hammer
& drill mode
Rotary hammer
WX331
WX332
WX331.1
230-240V~50Hz
750W 800W
0-1200/min
0-5000bpm
2.0J 2.5J
/II
20mm 26mm
13mm
30mm
2.3kg 2.7kg
A weighted sound
pressure L = 90.4dB
PA
A weighted sound
power L =101.4dB
WA
K & K : 3dB(A)
PA WA
When tested at hammer
only mode according to
2000/14/EC
Wear ear protection when sound pressure is over
80dB(A)
VIBRATION
INFORMATION
Vibration total values (triax cover sum) deter-
mined according to EN 60745
Vibration emission value
Hammer drilling
a
h,HD
into concrete
Uncertainty K=1.5m/s
Vibration emission value
a
Chiseling
h,Cheq
Uncertainty K=1.5m/s
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure .
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being drilled.
The tool being in good condition and well
maintained.
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation
of exposure level in the actual conditions
of use should also take account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimize your vibration exposure risk.
L = 92.3dB
PA
L = 103.3dB
WA
=15.674m/s
2
2
=16.065m/s
2
2
EN
5