Putting The Ac 3200-Ii Into Operation; Preparing The Ac 3200-Ii For Use - Sennheiser AC 32000-II Notice D'emploi

Putting the AC 3200-II into operation

Putting the AC 3200-II into operation

Preparing the AC 3200-II for use

You can set up the AC 3200-II on an even surface or mount it into a rack.
Setting up the device
CAUTION
Danger of heat damage to the devices
During operation, the AC 3200-II and the connected transmitters produce
considerable waste heat. If this heat cannot dissipate, it can cause damage to the
devices.
The devices are equipped with fans to assist dissipation of generated heat:
Make sure that the air vents
blocked and provide ducts of sufficient size or allow sufficient space to ensure a free
air flow between the devices.
Regularly clean the air vents on the sides of the AC 3200-II with a soft brush.
In order to avoid heat accumulation, make sure to install the AC 3200-II as the
uppermost device.
Never stack more than two devices directly one above the other.
Never place several NT 12-125D mains units directly next to one another.
To ensure that the AC 3200-II cannot slip on the surface on which it is placed, four self-
adhesive soft rubber feet are supplied.
CAUTION
Risk of staining of surfaces
Some surfaces have been treated with varnish, polish or synthetics which might cause
stains when they come into contact with other synthetics. Despite a thorough testing
of the synthetics used by us, we cannot rule out the possibility of staining.
Do not place the AC 3200-II on delicate surfaces.
Ensure that the base of the AC 3200-II is clean and free from grease before fitting
the rubber feet.
2
on the sides of the AC 3200-II are not covered or
AC 3200-II | 7