Tiger JAX-T Série Mode D'emploi page 22

4
Press the [Timer] key to
select either "Timer 1"
or "Timer 2".
The selected setting will switch
back and forth between "Timer 1"
and "Timer 2" each time the [Timer] key is
pressed.
Both the Timer lamp and the displayed "Timer
1" or "Timer 2" will blink.
Blinks
• The previously preset time will be displayed.
It is not necessary to set the timer again if the
desired completion time is already displayed.
Note
● The Timer function is not available in the following
cases.
• When the "Quick", "Mixed • Sweet", "Slow
Cook", or "Steam" menu is selected
• When the preset time is less than that indicated
in the following table
Menu
Plain
Porridge
Brown
Multigrain
• When "0:00" is blinking on the display
● If the Keep Warm lamp is on, press the [Keep
Warm/Cancel] key to turn off the lamp. (The Timer
function is not available while the Keep Warm
lamp is on.)
● If you do not operate the rice cooker within about
30 seconds after pressing the [Timer] key, an
alarm (3 beeps) will sound.
● If the [Timer] or [Start] key is pressed while the
rice cooker is in a state where the Timer function
is not available, an alarm (3 beeps) will sound.
● Do not use the Timer function when cooking rice
and side dishes concurrently.
22 22
Blinks
Minimum preset time
1 h 10 min
Cooking time + 2 min
1 h 30 min
1 h 10 min
5
Use the [Hour] and [Min]
keys to set the desired
completion time.
Press the [Hour] key to change the set time
in 1-hour increments. Press the [Min] key to
change that time in 10-minute increments.
Hold down the corresponding key to change
the time more rapidly.
Blinks
• The time is displayed in a 24-hour format.
Note
● Do not set the timer to more than 12 hours, as it
may result in spoiled rice.
6
Press the [Start] key.
The Timer lamp will turn on and
the Timer function is set.
If you selected the "Plain" menu, a one-short,
one-long beep alarm will sound. Otherwise,
only a one-beep alarm will sound.
On
• If you make a mistake or otherwise want
to reset the timer, press the [Keep Warm/
Cancel] key and repeat the procedure from
2
step on p.21.