10
Local legislation and regulations must be observed at all times. Such
stipulations do not form an integral part of this instruction manual.
It is on principle necessary for persons handling or using the sensors
to wear personal safety outfit such as protective goggles and protective
clothing.
The user is responsible for the instruction and training of personnel. In this
respect, additional copies of the instruction manual can be ordered from
your supplier. This instruction manual is an essential element of the sen-
sor equipment and must at all times be readily to hand for operators
directly at the location of employment of the sensors.
Before the sensor is removed from the process/process adapter, it must be
ensured that the process pressure has been reduced to a safe level and the
process temperature lowered to a safe range. Any escape of hot process
medium under pressure can cause damage to material/equipment or in-
jury to persons.
No modification whatsoever may be carried out on the sensors. Any
unauthorized modification or manipulation of the sensors results in imme-
diate expiry of the full scope of warranty granted by the manufacturer.
2.4
Ex-Declaration
2.4.1
Use in Ex-zones
Note: Before installation in Ex-zones, please read and observe the follow-
ing guidelines:
Ex-Classification:
II 1/2G Ex op is/ op pr IIA 95 °C Ga/Gb*
II 1/2G Ex op is/ op pr IIB 38 °C Ga/Gb*
Designation and number of the test certificate:
SEV 12 ATEX 0169 X
* Valid for sensors as of 01/2014. Previous sensors apply the following:
Ex-Classification: Ex II 1/2G T6/T5/T4; Designation and number of the test certificate:
SNCH 03 ATEX 3565 X
InPro
®
8000 Series
52 800 247
© 01/14 Mettler-Toledo AG, CH-8606 Greifensee
InPro
®
8000 Series
Printed in Switzerland