Falcon Classic Deluxe 110 Ceramic Mode D'emploi / Instructions D'installation & D'entretien page 21

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Pull the cooker forward to gain access to the cover box. Undo
the cover screws and lift clear. The cutout is located on the
earth plate beside the oven element
Iconnections. Disconnect the cutout wiring. Undo the fixings
that secure the cutout to the earth plate and remove. Fit the
replacement control and re-assemble in reverse order.
17. To Remove Oven Inner Back
Disconnect from electricity supply.
Open door and remove shelves. Remove screws and washers,
four on the left over as shown in the diagram and two on the
right oven and securing the inner back of the oven.
Carefully lift away the inner back. Reassemble in reverse order
making sure that the screws and washers are fully tightened.
18. To Remove the Fan Oven Element
Disconnect from electricity supply.
Remove the oven inner back - see section 17.
Remove the two screws from the top of the element and the
one from the bottom of the element inside the oven. Lift the
element out carefully, disconnecting the terminals connected
to the element (noting their positions). If it is not possible
to disconnect the leads in this way, pull the cooker forward
to gain access to the rear, remove the screws securing the
electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order. Check
the operation of the oven.
19. To Remove Oven Fan
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover. Disconnect the three terminals connected
to the fan noting their position. Remove the oven inner
back (see 17). Hold the fan blade and remove the centre nut
(left hand thread) two brass washers, fan blade and Circlip.
Unscrew the fan retaining nuts and washers (three off each)
and lift the fan away from the rear of the cooker. Fit the new
fan and reassemble in reverse order. Check the operation of
the oven.
20. To Remove the LH Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fixings that secure the cover and lift
it clear.
Remove the 2 screws 'A' and allow the plate to drop down.
Remove the 2 screws B, lower the upper plate and remove
through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fixings and withdraw element. Replace
the element and re-assemble parts in reverse order.
Top Element
Open the LH oven door and undo the fixings that secure the
heat shield. Remove the top element bracket fixings and
withdraw element. Replace the element and re-assemble
parts in reverse order. Check that the oven operates
satisfactorily.
21. To Remove Grill Element
Disconnect from electricity supply.
Remove grill pan from inside the grill compartment, remove
the enamelled front shield from the grill roof, by undoing the
two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
21