Falcon Classic Deluxe 110 Ceramic Mode D'emploi / Instructions D'installation & D'entretien page 14

Grill not cooking properly
Are you using the pan and trivet supplied with the cooker?
Is the pan being used on the runners, not the floor of the
compartment? Is the grill tray pushed fully back to the 'back
stop' position?
The knobs get hot when I use the oven or grill. Can I
avoid this?
Yes, this is caused by heat rising from the oven or grill, and
heating them up. Don't leave the oven door open. Make
sure that the grill pan is pushed right back to the 'back stop'
position when grilling.
If there is an installation problem and I don't get my
original installer to come back to fix it, who pays?
You do. Service organisations will charge for their call-outs if
they are correcting work carried out by your original installer.
It's therefore in your interest to keep track of your original
installer.
The oven is not cooking evenly
Do not use a tin or baking tray larger than 340mm x 340mm.
If you are cooking a large item, be prepared to turn it round
during cooking.
If two shelves are used, check that space has been left for the
heat to circulate. When a baking tray is inserted into the oven,
ensure that it is placed centrally on the shelf.
Check that the door seal is not damaged and that the door
catch is adjusted so that the door is held firmly against the
seal.
A dish of water when placed on the shelf should be the
same depth all over. (For example, if it is deeper at the back,
then the back of the cooker should be raised up or the front
lowered.) If the cooker is not level, arrange for your supplier
to level it for you.
The left hand oven is not coming on when turned on
manually
Is the power on? Is the clock illuminated? If not, there may be
something wrong with the power supply. Is the cooker supply
on at the isolator switch?
Has the time of day been set?
Is the key symbol ( ) showing in the display to signify that the
oven is locked? See the 'Clock' section of the instructions for
more information on the key lock feature.
The left hand oven not coming on when automatic
cooking
Assuming that the timer has been set correctly, has the oven
knob been left OFF by mistake?
Is the key symbol ( ) showing in the display to signify that the
oven is locked (see above)?
Oven temperature getting hotter as the cooker gets
older
If turning the temperature down using the oven control knob
has not worked, or has only worked for a short time, then you
may need a new thermostat. This should be fitted by a service
person.
The oven light is not working
The bulb has probably blown. You can buy a replacement
bulb (which is not covered under the guarantee) from most
electrical stores. Ask for an Edison screw fitting 15w 240v
lamp, FOR OVENS. It must be a special bulb, heat resistant to
300 °C. See the HELP leaflet for spares by mail order.
Before removing the existing bulb, turn off the power supply
and ensure that the oven is cool. Open the oven door and
remove the oven shelves.
Remove the oven inner back (see 'Servicing').
Once the light cover is accessible, unscrew it by turning it
anticlockwise (it may be very stiff ):
Now unscrew the existing bulb anticlockwise, taking care
to protect your fingers with a glove in case the bulb should
shatter.
Screw in the new bulb clockwise and then screw the bulb
cover back on.
Turn on the electricity supply and check that the bulb is now
illuminated.
14