Falcon Classic Deluxe 110 Ceramic Mode D'emploi / Instructions D'installation & D'entretien page 20

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Check the operation of the thermostat.
8. To Replace the Grill Controller
Disconnect from electricity supply.
Remove the control panel and lift up the hob (see sections 1
and 3). Disconnect the wiring from the controller. Remove the
two screws holding the controller to the mounting panel. Fit
the new controller and reassemble in reverse order. Check for
correct operation.
9. To Replace an Oven Door
Open the oven door. Support the door and remove the two
screws securing the upper hinge and gasket to the cooker
front. Remove the door from the lower hinge by lifting
slightly and moving outwards
The door is heavy, so take care.
Reassemble in reverse order.
10. To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to
alter the angle of the door. Loosen the bottom hinge fixing
screws and use the notch and a flat bladed screwdriver to
move the position of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
11. To Replace an Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing the
two retaining nuts. Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
12. To Change the Oven Door Latch
Remove the outer door panel - see section 13. Remove screws
'B' that hold the latch assembly to the inner door panel. Fit
the new catch and reassemble in reverse order.
Verify the door operation.
13. To Adjust an Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the base
of the keep:
Screw in or out as required until the required fit is obtained.
Retighten the locking nut.
14. To Replace an Oven Door Seal
Open the oven door. The seal has small hooks which hold it in
place by locating into holes in the rear door face on the main
oven and oven front face on tall oven. At the corner, pull the
seal diagonally away from the door centre until the hook is
released. Proceed to the next hook and release it in a similar
way, and so on.
You can use force if the hooks are stiff, as the old seal will be
discarded.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the four screws and washers are fully
tightened.
15. To Remove Grill Door
Remove the control panel (see section 1). Remove the left
hand side panel (see section 2). Remove the centre cover
strip (5 screws, 2 top, 2 bottom, 1 in middle). Remove the two
countersunk screws (1 each side) securing the grill hinge arms
to the front of the grill chamber.
NOTE: The arms are spring tensioned. Carefully remove the
grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket is fitted
between the hinge arm and the front of the grill chamber.
16. To Remove an Oven Element Thermal Cut-Out
Disconnect from electricity supply.
20