Possible Causes - Haier QFT15 Série Manuel D'utilisation

TROUBLESHOOTING TIPS
Problem
Time Remaining The estimated time may
jumped to a change when a smaller load
lower number than usual is drying
Cannot make The dryness Level, Temp or
a selection and option that you are trying to
the dryer beeps select is incompatible with the
twice chosen dry cycle
Dryer is running The Ext Tumble option was
but 00 is chosen
displayed in Time
Remaining
Clean Lint Filter Power button was activated
(message)
Dryer doesn't Fuse is blown/circuit breaker is
heat tripped; the dryer may tumble
but not heat
Inconsistent Type of load and drying
drying times conditions
Excess debris has collected
on the condenser preventing
proper airflow
Glow at the rear Heaters behind the drum
of the drum
Clothes are still The door was opened mid-
wet and dryer cycle. The load was then
shut off after a removed from the dryer and
short time a new load put in without
selecting a new cycle
Small load
Load was already dry except for
collars and waistbands
Dryer is not level
Clothes are Overdrying
wrinkled
Letting items sit in dryer after
cycle ends
Overloading
49-3000193

Possible Causes

This is normal.
This is normal.
This is normal. During extended tumbling, the time remaining is not
displayed. The extended tumbling option lasts approximately 60 minutes.
Press Start/Pause to begin a dry cycle and the message will disappear.
Check the building's fuse/circuit breaker box and replace both fuses or
reset both breakers. Your dryer may tumble if only one fuse is blown or
one breaker tripped.
The load size, types of fabric, wetness of clothes and the condition of the
lint filter, condenser, and/or air intake vent located on the front of the
dryer will affect drying times.
Refer to the Care and Cleaning section.
This is normal. Under certain drying conditions and room ambient
lighting, the glow of the heaters may be visible at the rear of the drum.
A dry cycle must be reselected each time a new load is put in.
When drying 3 items or less, choose Quick Dry or Time Dry.
Choose Quick Dry or Time Dry to dry damp collars and waistbands. In the
future, when drying a load with collars and waistbands, choose More Dry.
Move dryer to an even floor space or adjust leveling legs as necessary until
even.
Select a shorter drying time.
Remove items while they still hold a slight amount of moisture. Select a
Less Dry or Damp setting.
Remove items when cycle ends and fold or hang immediately, or use the
Ext Tumble option.
Separate large loads into smaller ones.
What To Do
25