Compatible Devices; Charging External Devices - SilverCrest SPBS 5000 B2 Mode D'emploi

Compatible devices

You can use the power bank to charge end devices that require a charging current
of at least 70 mA and a maximum of 2,1 A .
If the connected end device requires a current of less than 70 mA or more than
2,1 A, the power bank will switch itself off immediately after being switched on
with the ON/OFF button
your end device on the basis of the technical data of your end device .
NOTE
► If the device switches off automatically due to overloading, it can only be
switched back on if it has been charged for a short time beforehand with a
USB mains adapter . The device has switched itself off automatically due to
overloading .

Charging external devices

Connect the charging cable of your end device to the USB port
bank and to your end device .
♦ If charging does not start automatically, press the ON/OFF button
start the charging process .
The LED lights up for as long as the connected device is being charged .
Once your device is fully charged, the power bank switches off . To interrupt the
charging process, you can disconnect the end device . If your end device is not
fully charged and the
bank's battery is discharged . The power bank's battery must be recharged again
before you can charge end devices .
■ 12 │ GB │ IE │ NI
. In this case, check the power bank's suitability for
LED goes out during charging, this means the power
on the power
briefly to
SPBS 5000 B2