Charging With The Solar Panel; Charging With The Charger Cable - SilverCrest SPBS 5000 B2 Mode D'emploi

Charging with the solar panel

CAUTION
► Ensure that the ambient temperature does not exceed 35°C . This is particu-
larly important when using the device inside a motor vehicle .
You can charge the battery of the power bank with the solar panel
Ensure that the solar panel
sufficient sunlight, the solar LED
being charged . If the solar LED
available . In this case, change the location of the device or place the device in
direct sunlight . Once the solar LED

Charging with the charger cable

If there is no sunlight available, you can charge the power bank battery with the
charger cable .
CAUTION!
► Charge the device only in dry interior rooms as the device is not adequately
protected against water spray when the protective cover
► Due to the high current consumption, the power bank must be charged using
a USB mains adapter (not supplied) . Do not charge the power bank via the
USB port of a PC or notebook .
► Use only a USB mains adapter with an output voltage of 5 V and an output
current of at least 2 .1 A to charge the power bank .
► Use only the supplied charger cable
► Always disconnect the charger cable
replace the protective cover
♦ Open the protective cover
cable to the device's micro-USB port
♦ Connect the USB plug of the charger cable
USB mains adapter .
■ 10 │ GB │ IE │ NI
is receiving sufficient sunlight . As soon as there is
lights up orange to show that the battery is
does not light up, there is not enough sunlight
lights up green, the battery is fully charged .
to charge the power bank!
when charging is complete and
.
and connect the micro-USB plug of the charger
.
.
is removed .
to the USB connection of a
SPBS 5000 B2