Canon DR-5020 Mode D'emploi page 12

About the Power Supply
• Be sure to connect to a AC 220-240V (50/60 Hz)/AC 120V (60 Hz) power
supply.
• Ensure that the scanner is connected to an independent power outlet. Do not
plug the scanner into an outlet shared with another device. If you use an
extension cable, pay attention to the total amperage of the cable.
• If you are unsure of anything relating to the power supply, contact your store of
purchase or your local power company.
• Never place an object on top of the power cord or step on it.
• Never bundle the power cord or wrap the cord around an object such as a table
leg.
• Do not tug the power cord. When you remove the power cord, grip it by the plug
head.
• Keep the area around the power outlet free of obstacles.
Carrying
When you move the DR-5020/5080C, hold it firmly with both hands as shown in
the figure below and carry it carefully. If you carry it without holding its handles,
you may drop it, nip your fingers and cause unexpected injuries. The scanner
weights approximately 20 kg (44.2 lb).
Before you move the scanner, always turn the power switch OFF and disconnect the
power cord from the power outlet. Also, disconnect the SCSI cable from the connector.
WARNING
Moving the scanner with the power still ON or the SCSI cable still connected might
result in electrical shock.
9