Kyocera DF-710 Manuel D'utilisation page 16

English
2
Load the originals in the Document Processor, or
one at a time on the Platen.
Ensure the orientation of the originals is the same
as that selected for Hole Punch mode on the
machine.
NOTE:
machine for Document Processor and Platen
specifications.
3
Select other features as required and press Start.
4
The copies are automatically hole punched and
ejected onto the selected tray.
NOTE:
individually, therefore the location of the
holes may vary on each sheet.
On completion of the job, remove all the copies.
Interrupt Mode
1
Specify the settings for interrupt mode at from the machine operation panel.
NOTE:
guide. Specify the output tray at the machine.
2
Take out the any existing original and set the original to use for interrupt mode.
3
Set desired copier functions or output tray destination and press Start. Copying begins and
paper is output to the selected tray.
When done copying in interrupt mode, turn off interrupt copy mode from the machine itself.
4
Replace the original and press Start. Copying of the interrupted job resumes.
14
Refer to the Operation Guide for the
Holes are punched in each copy
For more information on interrupt mode operation, see the machine operation
DF-710, MT-710, BF-710, PH-5A, PH-5B AND PH-5C OPERATION GUIDE