Backwashing The Pool Filter; Storage And Winterizing - Polaris 480PRO Manuel De L'utilisateur

Masquer les pouces Voir aussi pour 480PRO:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Disposable Filter Bag
To replace disposable bag:
1. Push tabs of bag clip assembly
to the open position.
2. Disengage the alignment pin
and remove the old bag.
3. Fit cuff of disposable bag over
opening. Bag seam should face
the back of the cleaner and
hole in filter bag cuff should
engage with alignment pin.
4. Close bag clip assembly to
lock in place.
In-Line Filter
The in-line filter contains a filter
screen to keep debris that is not
caught by the pool filtration system
out of the Polaris.
To clean this screen, pull it out of
the in-line filter, rinse it and press
it firmly back into place.

Backwashing the Pool Filter

Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool
filter. After cleaning or backwashing, let the filtration system run for at least five minutes to
flush out the return lines before re-connecting the Polaris.

Storage and Winterizing

Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered under the warranty). Remove the UWF from the pool wall
using the UWF Removal Tool (part #10-102-00) included with the cleaner.
Disposable Bag
Alignment Hole
Back of Cleaner
Alignment Pin
Open
www.polarispool.com
Bag Clip
in Open
Position
In-Line Filter

Publicité

Table des Matières
loading

Table des Matières