Publicité
USI SPECIFICI DEL MODELLO RX
Tracker RX
Si tratta del visore notturno base equipaggiato con un duplicatore addizionale montato sull'obiettivo che aumenta
l'ingrandimento a 3,5x. L'apparecchio può essere utilizzato senza duplicatore. In questo caso le caratteristiche
corrispondono al modello NVB Tracker LT.
MANUTENZIONE
Pulire le lenti con detergente specifico studiato per ottiche con trattamenti multipli.
Soffiare polvere o sporco dalle lenti usando aria compressa, secca.
Pulire il corpo del Tracker con uno straccio morbido e pulito.
CONSERVAZIONE
Riporre sempre il visore (nel suo astuccio) in ambiente asciutto e ben ventilato evitando luoghi eccessivamente
riscaldati. La temperatura dovrebbe essere di +10°C. L'umidità non dovrebbe superare il 70%.
Togliere le batterie qualora si preveda un tempo di inutilizzo superiore a due mesi.
29
TROUBLESHOOTING
The binocular will not turn on...
Check that the battery is installed properly. Install the battery according to the (+) and (-) polarity, ensuring that the
markings on the battery and battery compartment correspond with one another. Check the battery contact to ensure
it is clean and free of corrosion; if necessary, clean the contact. Also, make sure that the contact spring is not
squeezed; it is possible for one to raise it.
Be sure that the cover of the battery compartment has been installed correctly as it may not have been
screwed on properly.
If necessary, replace the battery as it may be depleted and ensure that the binocular is in the "ON" position.
Distinct black dots appear on the screen...
These dots are minor cosmetic blemishes resulting from tube production processes and do not interfere with the
reliability or performance of the binoculars.
The binocular flickers, flashes or "snows"...
The binocular may flicker or flash when used in a bright environment; to correct this, place the caps over the objective
lenses and enter a dark environment. The binocular will restore itself to a natural functioning state in several minutes
or hours, depending on how long it had been exposed to the light.
The binocular may flicker for the first several seconds of use, even when in a dark environment, before it corrects
itself and functions properly.
The binocular may "snow" for several minutes after being exposed to a bright light source (daylight, a car's headlights,
fire, etc.) even if being operated in complete darkness.
The image is not focused...
Adjust the focus of the eyepiece and the objective (see point Use and Testing). Check that the lenses are not foggy or
dusty; if they are, carefully clean the external surfaces of lenses with a soft cotton fabric. Replace the battery if the
total battery charge is less than 2.2 V.
When the binoculars are brought into a warm environment from a cold one, condensation may appear on the internal
lenses; you must wait two hours before using the unit.
Visibility decreases or disappears...
Bright light sources, such as headlights, may cause visibility to decrease or disappear and the image to flicker.
Turn the power off and turn the binoculars away from the light source; visibility will restore itself in several minutes.
6
Publicité
