Table des Matières
Publicité
Soutien
Dépannage
Voici quelques suggestions pour résoudre les problèmes qui peuvent survenir.
Le séquenceur a cessé de fonctionner.
Assurez-vous que MIDI: Mode horloge dans le menu du système est réglé sur Auto, Master, ou Off, ou
si elle est définie à l'esclave qui MIDI: Clock est réglé sur Port MIDI ou USB et que l'horloge MIDI est
effectivement disponible à ce port.
An oscillator or filter sounds strange or out of tune.
In the System menu, choose Calibrate Analog Oscillators and Filters.
It is not necessary to run the calibration routine on a regular basis. You should only
It is not necessary to run the calibration routine on a regular basis. You should only
Note:
Note:
run it if you are experiencing problems.
The Real Time FX sliders are not behaving as expected or don't seem to go full
range.
In the System menu, choose Calibrate Slider 1 and Slider 2 Position and follow the inst ructions
In the System menu, choose Calibrate Slider 1 and Slider 2 Position and follow the inst ructions
In the System menu, choose Calibrate Slider 1 and Slider 2 Position and follow the inst ructions
to calibrate the sliders.
Still experiencing a problem?
From the System menu, choose Reset System Parameters.
Contacting Technical Support
If you are still having a problem with Tempest, contact Technical Support at
support@davesmithinstruments.com.
support@davesmithinstruments.com.
the operating systems (from the System menu, choose Show System Information), and the
purchase date.
If you have not already reset the Global parameters and run the calibration routine (see
If you have not already reset the Global parameters and run the calibration routine (see
"Troubleshooting," above), you should do it before contacting Technical Support. It's probably the first
thing they'll ask you to do.
Manuel d'utilisation Tempête
Please include your Tempest's serial number, the versions of
Please include your Tempest's serial number, the versions of
Soutien
85
Publicité
Table des Matières
