Fitting The Remote Panel; Safety Devices; Cleaning - Daikin Zanotti GS Notice De Mode D'emploi Et D'entretien

6.6 Fitting the remote panel:

Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in a vertical position.
Fit the connecting cable between panel and unit making sure not to bundle it with other cables.
ATTEN TI ON
M ax im um distance betw een panel and unit is 10 mt. For longer distances the special
"long distance module" should be used.
ATTEN TI ON
Check that the unit and its devices have suffered no dam ages during transport. Pay
special attention to the com ponents secured to the electric panel door and to the
refrigerating circuit pipes. M ount the unit as show n in the draw ings; m ake sure that
the electric connections are carried out properly.
6.7

Safety devices

mechanical safety devices
The following
1. Fixed front and side protections for evaporator and condensing unit,
secured by locking screws.
2. External fan protections placed on the evaporating unit, secured with screws.
electrical safety devices
The following
a. Protection of fans (belonging to motors) against high power absorption; with automatic reset.
b. High pressure switch (only for special components) to protect against excessive pressure; with
automatic reset.
W AR NI NG
Above devices have been developed to safeguard the operator's safety.

6.8 Cleaning

Clean the unit carefully. Remove any dust, foreign substances and dirt possibly deposited during handling.
Use detergents and degreasers.
ATTEN TI ON
Solvents are not allowed.
are supplied:
are supplied:
23