Ndustrio 191PD1G Manuel D'utilisation Et D'installation page 32

SWITCHING THE BURNER ON AND OFF
Lighting
1 - Turn on the gas supply tap.
2 - Press the knob (A) and turn it anti-clockwise
(pos. 1), while keeping button (B) pressed, to
light the pilot light.
Keep the knob pressed for about 15 sec. to
prime the thermocouple.
3 - Turn the knob anti-clockwise (pos. 2) to light the
burner.
4 - Turn the knob gradually anti-clockwise to adjust
the power of the flame down to the minimum
setting.
Turning off
1 - Turn the knob clockwise (pos. 3) to turn the bur-
ner off.
The pilot light will remain on to allow the burner to
be re-lit.
2 - Turn the knob clockwise (pos. 4) to turn off
the pilot light.
3 - Turn off the knob to ensure safety.
FILLING THE PAN
To carry out this operation, proceed as fol-
lows.
1 - Raise the lid (A).
IT
2 - Turn the water spout (B) towards the pan.
3 - Turn on the water taps (C) to fill the pan to a lev-
el between the two marks (D).
GB
For faster boiling times, use hot water only; use
cold water only when specifically required.
DE
4 - Turn the water spout outward and then close
the lid (A).
FR
Caution - warning
ES
Never use the appliance with no water in the
well, as this may damage its structure.
English
A
B
D
C
- 8 -
1
2
3
4
IDM-39615400700.tif
A
IDM-39615400800.tif
A B