Scope Of Delivery; Observe Ambient Temperature And Ventilation; Connecting The Appliance - Junker JFGB Série Mode D'emploi

Refrigerators contain refrigerant
and gases in the insulation. Refrigerant
and gases must be disposed of
professionally. Ensure that tubing of the
refrigerant circuit is not damaged prior
to proper disposal.

Scope of delivery

After unpacking all parts, check for any
damage in transit.
If you have any complaints, please
contact the dealer from whom you
purchased the appliance or our
customer service.
The delivery consists of the following
parts:
Built-in appliance
■
Interior fittings (depending on model)
■
Operating instructions
■
Installation manual
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy
■
consumption and noises
Bag containing installation materials
■
Observe ambient
temperature
and ventilation
Ambient temperature
The appliance is designed for a specific
climatic class. Depending on the climatic
class, the appliance can be operated at
the following room temperatures.
The climatic class can be found on
the rating plate, Fig. 8.
Climatic class
SN
N
ST
T
Ventilation
The air on the rear panel of
the appliance heats up. Conduction of
the heated air must not be obstructed.
Otherwise, the refrigeration unit must
work harder. This increases power
consumption. Therefore: Never cover
or block the ventilation openings!
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in
the compressor may have flowed into
the refrigeration system.
Before switching on the appliance for
the first time, clean the interior of
the appliance (see chapter "Cleaning
the appliance").
Electrical connection
The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply match
the values of the mains supply. This
information can be found on the rating
plate. Fig. 8
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
en
19