Disposal, Scrapping - Husqvarna FS 3500 G Manuel D'utilisation

• Refill the reservoir with new oil. Ensure that the machine
is fully lowered.
NOTICE! Do not overfill!
Yearly maintenance
Replace outer and inner air filter
Remove the rear cover by opening the 2 air filter housing
clamps and pulling the housing off. Replace both filters and
refit them in reverse order.
CAUTION! The 2 air filter housing clamps
can not be closed unless the outer air filter
is properly installed.
Lubrication
The image shows all the lubrication points (8 grease nipples).
Clean the nipple. Replace broken or blocked nipples.
• Lubricate the front wheels.
• Lubricate the front axle pivot bearings.
• Lubricate the blade shaft. Two pumps at each end.
• Lubricate rear axle bearing.
30 –
English
MAINTENANCE AND SERVICE
Lubricate blade shaft on top of the base plate.

Disposal, scrapping

This product should be submitted to an appropriate recycling
station in accordance with local requirements. By ensuring
that this product is taken care of correctly, you can help to
counteract the potential negative impact on the environment
and people that can otherwise result through the incorrect
waste management of this product. For more detailed
information about recycling this product, contact your
municipality, your domestic waste service or the shop from
where you purchased the product.