Publicité
EN
LEGIONELLA BACTERIA FUNCTION
Legionella are small rod shaped bacteria which are a natural constituent of all fresh waters. Legionaries'
disease is a pneumonia infection caused by inhaling of Legionella species. Long periods of water stagnation
should be avoided; it means the water heater should be used or flushed at least weekly.
The European standard CEN/TR 16355 gives recommendations for good practice concerning the prevention
of Legionella growth in drinking water installations but existing national regulations remain in force.
This electronic storage water heater is sold with a thermal disinfection cycle function enabled by default.
Every time the product is switched on and every 30 days, the thermal disinfection cycle run to heat the water
heater up to 60°C.
Warning: when this software has been carrying out the thermal disinfection treatment, water temperature
can cause burns. Feel water before bathing or showering.
TECHNICAL CHARACTERISTICS
For the technical specifications, refer to the nameplate (the nameplate is located next to the water intake/
outlet pipes).
Range
Weight (kg)
Installation
Model
Q
(kWh)
elec
Q
(kWh)
elec, week, smart
Q
(kWh)
elec, week
Load profile
L
wa
η
wh
V40 (l)
Useful volume (I)
The power consumption data in the table and the other information given in the Product Data Sheet (Enclo-
sure A to this manual) are defined in relation to EU Directives 812/2013 and 814/2013.
The products without the label and the data sheet for water heaters and solar devices, stipulated in regula-
tion 812/2013, are not intended to be used in such assemblies.
The device is equipped with a smart function that allows you to adapt the consumption to the user profiles.
If operated correctly, the device has a daily consumption of "Qelec*(Qelec,week,smart/Qelec,week)"less
than that of an equivalent product with no smart function" .
The data shown in the energy label refer to the product installed vertically.
This appliance is conforming with the international electrical safety standards IEC 60335-1 and IEC
60335-2-21. The CE marking of the appliances attests its conformity to the following EC Directives,
of which it satisfies the essential requisites:
- LVD Low Voltage Directive: EN 60335-1, EN 60335-2-21, EN 60529, EN 62233, EN 50106.
- EMC Electro-Magnetic Compatibility: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3.
- RoHS2 Risk of Hazardous Substances: EN 50581.
- ErP Energy related Products: EN 50440.
20
Table 3 - Product information
30
50
16
21
Vertical
Vertical
Refer to the nameplate
3,096
7,290
13,016
25,234
18,561
32,166
S
M
39,0%
40,0%
-
77
25
45
80
27
Vertical
7,443
26,456
34,333
M
15 dB
40,0%
110
65
100
32
Vertical
7,099
25,560
31,860
M
39,6%
115
80
Publicité
