Makita DCL180 Manuel D'instruction page 6

CAUTION:
Before inserting the battery cartridge into the
•
tool, always check to see that the switch
trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch
trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes
•
too full, or the suction force weakens.
Be sure to empty out the dust inside the
•
cleaner itself. Failure to do so may
cause the filter to be clogged or the
motor to be damaged.
1
009992
In order to drop dust sticking on the filter in
the capsule, tap the capsule 4 or 5 times
with your hand.
009993
Now point suction inlet downwards, turn
capsule in direction of arrow in diagram,
and disconnect capsule slowly and straight.
1. Suction inlet
2. Capsule
2
1. Capsule
2. Suction inlet
1
2
NOTE:
Dust may spill out when capsule is
•
opened, so be sure to set a garbage
bag beneath capsule.
1
009994
Remove accumulated dust from inside of
capsule and off of prefilter.
1
009995
Twist prefilter in direction of arrow to
unfasten securing lip from cleaner unit and
then pull off prefilter.
1
009996
Clean out fine dust from prefilter. Next,
remove filter, and lightly tap to dislodge dust.
Reassembly
1
009997
6
1. Prefilter
2. Capsule
2
1. Prefilter
2
2. Securing lip
1. Prefilter
2. Filter
2
1. Filter