Publicité
Les langues disponibles
Les langues disponibles
Loop
Address
1
1
100000000
2
13
101100000
3
25
100110000
N
(N-1)*12+1
The dipswitches setting for DMX address see the " DMX Address
Quick Reference Chart ".
DMX Control Parameter Chart
Channel No
DMX512 fig.
0~49
Control
50~99
Channel 1
mode
100-149
150~255
0
Color select
Channel 2
1-255
Pattern
Channel 3
0-255
select
0-127
Vertical
Channel 4
128-191
move
192-255
1~127
Horizontal
128-191
Channel 5
move
192-255
Vertical
Channel 6
0-255
rotate
Horizontal
Channel 7
0-255
rotate
0-127
rotate
Channel 8
128-191
192-255
0
zoom
1-85
Channel 9
86-170
171-255
©Copyright Lotronic 2013
Binary
Dipswitches
＃1
＃1 + #3+#4
＃1 + #4+#5
Content
Sound control
Auto- beam
Auto-animation
manual
Laser off
Green, red, blue, yellow,
cyan, pink, white
patterns
Manual
From down to up speedy
From up to down speedy
Manual
From right to left move
From left to right move
From slow to speedy
From slow to speedy
manual
Anticlockwise rotate
Clockwise rotate
static
From small to big
From big to small
Auto zoom
Channel
Pattern size
10
Spot and line
Channel
11
Channel
Twinkle
12
speed
PC Control
If it is set to ILDA mode (use PC software to control light), you just need to
connect the ILDA signal to the DB25 jack. ILDA mode (PC control) and
built-in program mode can be identified and transformed automatically.
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work,
please check the power supply and the input voltage.
2. In Stand-Alone operation, if the power supply indicator is light up and
sound active indicator isn't light up, but the laser is shut off doesn't work.
A. Because sound is too small make for laser shut off in sound active,
please increase the music volume or increase audio sensitivity with
sensitivity knob, please check as below.
B. Please check if unit has been set up in slave mode, then set up in
master mode.
3. In Master-Slave operation, slave unit don't function, please check as
below.
A. Make sure to there's only one master in the chain, and the others
are set in slave mode.
B.Make sure to take a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator
is unlighted, please check as below.
A. Make sure to set up the DMX mode.
B. Make sure to have a good connection.
5. In DMX operation, the unit can't be controlled by the DMX console, but
the DMX signal indicator is flashing, please make sure the DMX console
and unit have the same channel.
6. If the output beam direction above isn't the right way, please restart the
unit.
7. If the unit is fail, please turn off the unit, then turn on again after 5
minutes.
8. In PC mode operation, the laser is OFF after the swimming fish, please
check as below
A. Please press the button of animation
B. Make sure the SD card is insert with good connection
After trying the above solution you still have a problem, please
contact your dealer or our company for service.
3
0
normal size
1-255
Small to big
0-255
Line to spot
0-22
Slow to speedy
Publicité
