Potential Breakdowns And Their Elimination - Agu Wally Mode D'emploi

then the zero value of weight will show. The scales are ready for
measuring.
2. Pull the silicone cover out and insert the top limiter in its place.
3. Pull up and open the bottom limiter sideways until it clicks to put the
device into the height measuring mode. The initial value of 46.0 cm
will show on the screen.*
*Note: if this does not happen, make sure that the bottom limiter is in the
initial position and press the «ZERO» button to set the starting parameters.
4. Carefully place the baby on the scales so that the head touches the
top limiter, and the feet touch the bottom limiter of the measurement
board.
5. The screen will show the baby's weight and height.
6. Press the «HOLD» button or the button in the Application to save
these readings. Thus you will be able to compare the results with
previous readings. The results and difference with the previous meas-
urement (if there were any) will flash in the screen several times, and
then the scales will turn off automatically.
7. Take the baby off the scales and remove the underpad.
8. The scales will turn off automatically after 2 minutes. You can also press
and hold the «ZERO» button for 3 seconds to turn off the scales by force.
11

POTENTIAL BREAKDOWNS AND THEIR ELIMINATION

If any trouble occurs while using the device, please check the following list first.
Problem
The scales do not
send the data to
the Application
Setting the wireless
communication
signal in the
smartphone failed.
EN
Solution
Check if the wireless communication is on in your device
Check if the scales are on and placed within the reach of
a wireless communication signal
Check the batteries serviceability, and replace them if necessary
Exit the Application and restart it
Restart your smartphone and turn wireless communication on once again
Make sure that the wireless communication version in your device
is 4.0 or later
Make sure that only one device is connecting to the scales with
wireless communication
51