Asist AE7AF120IN18 Mode D'emploi page 37

CLEANING AND MAINTENANCE
- Switch off the vacuum cleaner.
- Unplug the power cord.
- Disconnect the metal hose, aluminum pipe and tank.
- Clean the inlet connector, metal hose, aluminum
tube and keep them aside.
- Use a damp cloth to clean plastic parts.
- Empty the collecting container, tap it to release the
insert and wash it if necessary.
- Brush the dust off the washable fi lter and wash it if
necessary.
- Do not use cleaning agents, solvents or sharp
objects for this purpose.
Storage when not used for a long time
Do not store the device in a place where the
temperature is high. If possible, store the device in a
place with a constant temperature and humidity.
Possible defects
In case of any problems, switch off the device and
always unplug the power cord from the electrical
outlet.
The following problems may occur during operation:
Faults Causes
1. Power cord
is not securely
connected or
Motor does
damaged
not run
2. Malfunctioning
switch
1. Clogged hose
or nozzle
Poor 2. The fi lter is
suction dirty
power 3. The dust
container is not
attached properly.
SPEciFicATiOnS
power consumption: 1200W
power supply value: 230V / 50Hz
container capacity: 18L
suction power:> = 19Kpa
noise level: <78db
Solutions
1. Connect the cable
or replace it
2. Replace the
switch
1. Loosen the hose
or nozzle
2. The fi lter must be
cleaned
3. Secure the dust
container correctly.
37
metal tube coated with plastic: 1.2m
aluminum tube: 0.23m
HEPA fi lter "FIRE proof"
Cable 4m
Subject to change.
EnViROnMEnTAL PROTEcTiOnWASTE MA-
nAGEMEnT
Power tools, accessories and packaging should be
provided for recycling and not to harm the environment.
Do not dispose of power tools into household waste!
According to Directive 2012/19/EU of the European
Parliament and of the Council on waste electrical and
electronic equipment (WEEE) and its approximation
in national laws, unfi t power tools must be handed
over at the point of purchase of similar equipment, or
in available collection points designated for collection
and disposal of power tools. Such disposed power
tools will be collected, disassembled and delivered for
environment-friendly recycling.
WARRAnTY
In the attached material, you will fi nd our warranty
conditions.
date of Manufacture
The date of manufacture is incorporated in the serial
number indicated on the product label.
The serial number has the format ORD-YY-MM-SERI
where ORD is the order number, YY is the year of
manufacture, MM is the month of manufacture, SERI
is the serial number of the product.