Asist AE7AF120IN18 Mode D'emploi page 36

Quick fi lter cleaning
5 times press the tube dust knob on the top cover as
shown if the HEPA fi lter
clogged with dust (reduced suction power).
Blowing function
- Insert the suction hose as deep as possible into
the air outlet hole at the top of the engine cover and
secure by turning it clockwise. Please check the
correct direction according to the arrow in the picture.
(Release it by turning it counterclockwise and pull it
out). When the vacuum cleaner is on, you can use the
suction hose to blow dust, blow leaves, etc.
Switching on and off
To switch on the vacuum cleaner, set the switch to the
‚I' position.
To switch off the vacuum cleaner, set the switch to the
‚0' position.
CAUTION: Always unplug before cleaning or mainte-
nance.
Place the device on a fl at surface.
Make sure the fi lter is seated in place.
Connect the aluminum suction tube to the appropriate
hole.
Before vacuuming the ashes from the stove, make
sure that the stove and the ashes have cooled down
suffi ciently. Make sure the stove is switched off before
you start vacuuming.
Make sure that the voltage in the el. network cor-
responds to the data on the label on the vacuum
cleaner.
Plug the power cord into an electrical outlet.
Use the ON (I I ') / OFF (' 0 ') switch to turn on the
device.
Vacuum the ash with an aluminum tube directly from
the fi replace or stove. Hold the nozzle of the vacuum
cleaner about one centimeter above the ash
If the container is about half full, empty the collection
container and clean the dust fi lter.
In any case, we recommend vacuuming up to 2/3 of
the container capacity.
Once you have fi nished vacuuming the stove or
fi replace, also clean the appliance and the suction
fi lter (do outside).
After use
Press the power key to the ‚0' position to turn off the
device.
Unplug the power cord.
Wind the power cord.
Disconnect the suction tube from the device. Remove
the main part.
Empty and clean the container of dust and ash. Wash
the container.
Dry the container well.
Remove the fi lter and clean and wash it thoroughly.
Filter cleaning
Direct a stream of air into the fi lter and, if necessary,
clean the fi lter with a stream of clean water. Never
clean the fi lter with a sharp object. Then dry the fi lter
thoroughly.
Once you have cleaned the fi lter, check that it is still
suitable for further use. If the fi lter is damaged, crac-
ked or too worn, replace it with a new original fi lter.
36