Publicité
Les langues disponibles
Les langues disponibles
• The device can only be disconnected from the mains sup-
ply by pulling out the mains plug or the connector plug.
• The device can only be opened by technical experts, even
during repair. The device must be unplugged from the
power supply before opening. Live parts inside the device
may still be live for some time after unplugging from the
power supply.
For protection of the user:
DANGER
CAUTION
away from this area during operation.
CAUTION
and installing the device.
CAUTION
the device.
WARNING
to be processed. Otherwise there is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustible gases
- body parts, hair, clothing and jewelry getting caught.
DANGER
cessing. This also applies to any extra energy produced in
other ways, e.g. through light irradiation.
DANGER
WARNING
- flammable materials
- incorrect container size
- overfilling of media
- unsafe condition of container
- glass breakage as a result of mechanical shaking power.
Never touch the moving
parts during operation.
There is a crushing hazard be-
tween the moving shaking table
and the casing. Keep your hand
There is a crushing hazard be-
tween the device and the table.
Be careful when transporting
Because of the heavy weight (26
kg) of the device, at least two
persons are needed for carrying
Wear your personal protective
equipment in accordance with
the hazard category of the media
Only process media that will not
react dangerously to the extra
energy produced through pro-
Process pathogenic materials only
in closed vessels under a suitable
fume hood. Please contact IKA
if you have any questions.
Beware of hazards due to:
For protection of the device and accessories:
• Set up the device in a spacious area on an even, stable,
clean, non-slip, dry and fireproof surface.
• The voltage stated on the type plate must correspond to
the mains voltage.
• Removable parts must be refitted to the device to prevent
the infiltration of foreign objects, liquids etc..
• Protect the device and accessories from bump and impact.
• Avoid allowing objects to push or strike the shaking table.
NOTICE
• Place the vessels securely on the shaking table or on the
chosen mat.
• Firmly secure the accessories and vessels in place, other-
wise shaking vessels could be damaged or projected out.
• Position one single shaking vessel in the centre and sev-
eral shaking vessels so that they are evenly spread out.
• Always load the samples evenly on the device.
Performing trials:
NOTICE
- the medium splashes out of the vessel
- the device is not running smoothly
- dynamic forces start to cause the device and/or the ves-
sels placed on it to move around.
• Make certain that the device is set at the lowest speed
(left hand position) before commissioning; otherwise, the
device will start to run at the speed set in last operation.
Gradually increase the speed
• After an interruption in the power supply or a mechani-
cal interruption during working process, the device will
restart automatically.
®
The weight of the load must not
exceed 15 kg. Do not exceed the
maximum permissible shaking
weight.
Reduce the speed if:
13
Publicité
