FireWare SMOKY MULTI SOCKET Mode D'emploi Utilisateurs page 13

User Manual
EN
FireWare Smoky Multi Socket
Place the appliance stabile on a flat surface and make sure the appliance cannot fall over.
Always place the appliance in an easily accessible location, so that the appliance can be
turned off 'quickly and easily' without running the risk of the appliance falling over.
Make sure that the appliance and the wires can be placed in a safe location so that no one
can slip, trip or fall over it. Tape the wires to the floor if necessary. The smoke unit contains
a liquid, if the appliance falls over this could lead to a SHORT-CIRCUIT!
The metal needle in the middle of the smoke unit is vulnerable. In case this part breaks
down the appliance will be damaged beyond repair.
For your own safety you need to disconnect the appliance before filling up the smoke liquid.
Make sure the smoke unit is NEVER filled with liquids other than the one prescribed. This
can damage the appliance beyond repair.
Make sure you do not breath in the fumes of the liquid; this will damage your health.
Pay attention that you do not apply smoke liquid to the plugs. This can cause a SHORT-
CIRCUIT!
NEVER drink the smoke liquid. Keep it out of reach of children. In case of contacts with the
eyes immediately rinse with plenty of water and consult a doctor. Contact a doctor if some-
one has ingested the smoke liquid. Show your doctor the packaging of the smoke liquid.
In order to dose even better it is recommended to first remove the air from the syringe
by pointing the syringe upwards and carefully pressing until all the air has disappeared.
When the liquid has been placed in the smoke unit the bottle with smoke liquid needs to be
sealed off immediately. Make sure the bottle with the childproof stopper is sealed off prop-
erly. Store it outside the reach of children.
If there is still liquid in the syringe after filling the smoke unit return this to the bottle.
Always empty the syringe after use!
Clean the liquid on the casing with a dry cloth in the unlikely event that a surplus of smoke
liquid has ended up in the smoke unit. If the metal needle is filling up with smoke liquid it
takes a bit longer before the appliance will produce smoke. You can remove some liquid or
wait until a sufficient amount has evaporated.
DO NOT touch the smoke unit during and after use. It becomes HOT.
www.FireWare.nl FireWare Smoky Multi Socket
13