IntesisHome DK-AC-WIFI-1A Guide D'installation page 6

IntesisHome® DK-AC-WIFI-1A
7. Antenna location
Locating the external antenna in a proper location and position will improve communication between the Intes-
isHome device and your Wi-Fi Router or Access Point (AP).
Remember to correctly screw the antenna connector in a clockwise direction until it stops.
Important: Avoid placing the
antenna next to metal surfaces.
Fix the external antenna preferably as close as possible from the Wi-Fi signal source (Access Point or Router).
Please, make sure that you place the antenna in a vertical position and pointing directly to your Wi-Fi Router
or Access Point (AP).
Antenna in vertical position and pointing to the
Wi-Fi Access Point or Router.
If you have coverage problems after installation, please visit the connectivity support section in our site at
www.intesishome.com/support/faq
8. Temperature Sensor location
Connect the temperature sensor to the device Temperature Sensor connector (Figure 1) and fix the other end
next to the Air Conditioner intake air sensor.
See www.intesishome.com/docs/DK-AC-WIFI-1A_Install_Sketch.pdf
Important: When possible, try to check Wi-Fi coverage in the installa-
tion location. Good Wi-Fi level is strongly recommended.
Antenna in horizontal position and not pointing
to the Wi-Fi Access Point or Router.
INSTALLATION GUIDE
for more information
Figure 4
6