IntesisHome DK-AC-WIFI-1A Guide D'installation page 4

IntesisHome® DK-AC-WIFI-1A
4. Installation overview
1. IntesisHome device
2. External antenna
3. Wi-Fi Access Point or Router
4. S21
5. Temperature Sensor
5. Device connections
1. Unplug the Air conditioner (AC) unit from the power supply line.
2. Access to the main Printed Circuit Board.*
3. Locate the socket connector marked as S21*
4. Select a location for the IntesisHome device. See section 6 for more information.
5. Connect the A-end (the long one) of the supplied cable to the Air Conditioner S21 connector and the
B-end (the short one) to the device AC connector.
6. Connect the external antenna into the antenna connector. Make sure you screw the antenna connector
in a clockwise direction until it stops.
7. Install the Temperature Sensor. See section 8 for more information.
8. Place the antenna outside the AC, preferably in a vertical position and pointing directly to the Wi-Fi
Router or Access Point (AP). See section 7 for more information.
9. Close the Air Conditioner unit.
10. Plug the AC to the power supply line. If connection with the Air Conditioner has been successful, Inte-
sisHome device LED will start blinking Green and then will change to steady Green.
* See Daikin installation or service manual for detailed information.
INSTALLATION GUIDE
Figure 2
4