Publicité
Les langues disponibles
Les langues disponibles
All connections shall be made by a qualified serviceman and only on a not working, disconnec-
ted from the gas supply, appliance.
Connect the regulator to the cylinder making sure that the seals are in place (See diagram above), if
the seals are old or damaged or if one of them is missing, the device cannot be used until the seals
are replaced. The valve must remain in the position it is installed at the factory. Changing the angle of
the valve with anti-tilt valve results in closing the gas supply to the device and thus switching it off.
ATTENTION!!!
The anti-tilt valve is a protection against overturning of the appliance, thanks to which in the event
of the appliance overturning, the valve automatically cuts off the gas supply to the controller, which
extinguishes the flame.
ATTENTION!
The appliance should be connected to the gas source only when the heater is turned off and the
cylinder valve is turned off.
Never connect the gas cylinder directly to the appliance without the regulator!
ATTENTION!
It is forbidden to use open fire during the installation process or connecting the cylinder. Failure
to comply with this prohibition may result in fire, explosion, property damage, personal injury,
and even loss of life.
ATTENTION!
Gas garden fireplaces are designed to work with a propane and propane-butane cylinder in size
of 5 and 11 kgs (the sizes may vary depending to the country you are buying them in).
The device is sold with complete automation with anti-tilting valve.
Before replacing the cylinder, make sure that the device is not near to any sources of fire or
other sources that could ignite.
It is essential to close the gas supply valve on the cylinder or regulator after each use.
If you feel any gas leakage, you must absolutely stop using the device, if it is running or if it
is turned off, do not start it. Then contact the service center.
ATTENTION:
It is recommended to periodically check the quality of connections for all gas hoses including
the rubber flexible hose (at least once a month or whenever the cylinder is replaced). If there
are visible cracks, damage or other signs of damage, the elements should be replaced with new
ones of the same length and equivalent quality.
EN
47
Publicité
