Kratki UMBRELLA Instructions D'installation Et D'utilisation page 45

FIRST START
Before first use, make sure that all connections of individual system components have been made in
accordance with the instructions contained in the manual. Incorrect connection of the gas control
system may result in its damage.
During the first few ignitions a specific smell may be perceptible, persisting even for several hours after
using the device. This phenomenon is associated with the burning of paint. Animals may be particular-
ly sensitive to smells caused by burning off paint. To speed up the process, it is recommended to heat
the device to maximum flame for several hours.
INSTALLATION OF GAS CONTROL SYSTEM
ATTENTION!!!
This appliance together with the gas control system can only be installed at the factory settings.
ATTENTION!!!
Individual elements of the gas control system should be installed in accordance with the instruc-
tions in this manual.
The standard gas control system includes a manual control valve. Elements of the system should be
installed in places designated for this. Moving them may expose the device to damage due to harmful
temperatures or flooding.
The appliance can only work with the gas control valve supplied with the appliance. Connections of in-
dividual system components have been made in such a way as to prevent their improper connection.
WARNING! The device is equipped with a very sensitive anti-tilt valve. Shaking of the ground
or the device itself as a result of impact or other forces may cause cutting off the gas supply to
the device, and thus shutting it down. If you notice that the device does not burn, immediately
turn the knob to the closed position clockwise and according to the instructions in the section
„lighting the device".
EN
45