Table des Matières
Publicité
Warning:
As with all machinery there are certain
hazards involved with the operation and
use. Exercising respect and caution will
lessen the risk of personal injury
considerably. However, if normal safety
precautions are overlooked or ignored it
might result in personal injury to the
operator or damage of property.
! Read and become familiar with the
entire
user
machine's applications and limitations
as well as the specific potential hazards
particular to it.
! Control damaged parts. Before further
use of the machine, a guard or other
part that may be damaged shall be
inspected to ensure that it will operate
properly and perform in its intended
function. Check for alignment of the
moving parts, breakage of parts,
mounting, or any other conditions that
may affect its operation. A guard or
other parts that are damaged should be
properly repaired or replaced.
! Disconnect
the
servicing it and before replacing any
parts such as blades, bits, cutters etc.
! Keep guards and slide bars in place and
in working order.
! Always carry ear protectors/defenders
and
eye
protection/goggles,
protection and working gloves.
! Always
remove
keys/spanners etc. Form habit of
checking to ensure that keys and
spanners etc. are removed from the
machine before turning it on.
! Never use the machine under influence
of drugs, alcohol or medication.
! You must never stand on the machine,
injury could occur in case of a fall.
! You must never leave the machine
running unattended. Always turn the
power off. Don't leave the machine until
it comes to a complete stop.
! Always remove the plug from the
electric outlet when adjusting, changing
parts or repairing the machine.
manual.
Learn
machine
before
adjusting
! Ensure that the electric cable is fully
protected and there is no danger of
damage of equipment or materials.
Always inspect the cable thoroughly
before use and replace if any damage is
apparent.
! Keep your hands well clear of the log,
pusher and wedge at all times. Never
touch the moving parts of the machine
when the machine is switched on.
! Do not wear any jewellery or loose
the
clothing that could be snagged by the
log splitter.
Electric connections
Connect the main lead to a standard
electric
specification listed on the type tag/name
plate.
THIS APPLIANCE MUST HAVE A
Interference with the electric system,
can be dangerous, always contact a
qualified electrician.
Extension leads
If an extension cable is to be used, always
face
make sure water proof cables are used
and that the connector is kept well clear of
any water.
Since the cable will produce a voltage
drop, that will prevent the engine from
supplying full power and reduce the
machine's function, it is essential that the
conductors in the cable conform the
following specifications.
0-10 meters - diameter of conductor - 1,5
mm
2.
Logsplitters with 380 V engine will not
have this problem.
Logsplitter with 230 V engine acquires 16
amperes.
13
outlet,
which
WARNING!
GROUND CONNECTION
equals
the
Publicité
Chapitres
Table des Matières
