Before You Begin; Tools And Parts Needed; Parts Included; Additional Connection Cables (Optional) - Gaggenau Vario 400 Série Notice De Montage

Before you begin

IMPORTANT:
The instructions in this document are for mounting the
control knobs only. A safe operation of the control knobs
is only possible, if the installation instructions are
followed exactly.
Before you install the control knobs you must read and
understand the Installation Instructions and Safety
Instructions for your gas cooktop.
9
WARNING
Risk of burns!
Do not install the control knobs behind the
cooktop. This might force you to reach over fire or
steam and cause injury.
9
WARNING
Risk of injury!
Follow the safety instructions in the manual for the
relevant appliance.

Tools and Parts Needed

Phillips Head Screwdriver
▯
Pencil
▯
Drill with 2" (50 mm) bit
▯
Tape Measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.

Parts included

Additional connection cables (optional)

Additional connection cables can be ordered if required.
1 ft (0.3 m) D-Bus cable (article no. 12013604)
▯
3.2 ft (1 m) D-Bus cable (article no. 12013606)
▯
5 ft (1.5 m) D-Bus cable (article no. 12013607)
▯
en-us
3